WATERBORNE 1-2K PU-A SELF-SEALER FOR PARQUET
NAT4165.XX-XX
Naturaqua Floormax Top BF75 is a water-based acrylic-polyurethane self-sealing lacquer, specific for the treatment of parquet.
Good wear resistance; can be used in combination with a hardener to improve the strength and durability of the treated surface.
Transparent, odorless, it respects the environment and the health of the operators, having a very low VOC content.
Once applied it develops high levels of protection against wear and abrasion on any wooden surface, already sanded or to be restored.
Good performance combined with easy use of the 1-2K technology and easy spreading.
Compliance with EN71.III Safe for children's toys.
Compliance with DIN 68861-1:2011 Resistance to cold liquids.
Compliance with DIN 53160 Resistance to saliva and perspiration.
Conformity to French VOC Classe A+.
Cod. NAT4165.1-XX 6 x 1 L
Cod. NAT4165.2,5-XX 2 x 2,5 L
Cod. NAT4165.5-XX 2 x 5 L
Cod. NAT4165.10-XX 1 x 10 L
Cod. NAT4165.20-XX 1 x 20 L
HARDENER NAT4100-2K
Cod. NAT4102-2K 12 x 100 ML
Cod. NAT4100-2K 12 x 250 ML
Cod. NAT4101-2K 12 x 500 ML
Cod. NAT4105-2K 6 x 1 L
Cod. NAT4103-2K 2 x 2,5 L
Cod. NAT4104-2K 2 x 5 L
LOGIN
Sand the product to obtain a smooth, clean surface free from oils, greases, waxes, silicones and old paint.
Apply a water-based resin binder, loaded with wood dust, to fill cracks and irregularities and/or to even out the surface and homogenize its absorption.
After 1-2 hours, sand with 120-180 grit sandpaper.
Before applying the lacquer, carefully vacuum up all the sanding dust and remove any residues with an antistatic cloth.
The minimum working temperature is 10 °C.
ONE-COMPONENT APPLICATION
Apply the product and then, after 1-2 hours sand with abrasive grit 180-220 sandpaper, carefully vacuum up all the sanding dust and remove any residues with an antistatic cloth.
Then apply the second coat of NATURAQUA FLOORMAX TOP BF75. Although self-sealing for best results, the use of a base coat HT66 or HN41 should be considered.
For an application in a hot climate we recommend adding minimum 10% of XA9103 retarder.
TWO-COMPONENT APPLICATION:
Mix the lacquer and the hardener NAT4100-2K in a 10:1 ratio, stir well, then add 5-10% of preferably demineralized water and stir again.
After 10 minutes apply the product and then after 1-2 hours sand with 220 grit sandpaper, carefully vacuum up all the sanding dust and remove any residues with an antistatic cloth.
Then apply the second coat of NATURAQUA FLOORMAX TOP BF75 .
Pot life: 4 hours
Wait for 2-4 hours.
Sand with 180-220 grit sandpaper or mesh and dust perfectly before applying the second coat.
Apply at least a second coat.
Wait 12-24 hours for complete drying and maximum hardness.
Related products
