WATERBASED LACQUER FOR PARQUET
NAT4100-XX
Waterbased varnish eco-friendly for the parquet floor treatment. High performances with the convenience of a single component / catalyzable technology. It can be used as a single component product, or can be activated with Catalyst 4100-2K, with the ratio varnish : catalyst = 10 : 1. Respects environment and the workers’ health, being waterbased and practically VOC free. With Parketlack very high protection levels can be obtained against wear and abrasion, for traditional wooden floors, pre-sanded or to be restored.
Sheen (Gloss):
- 0/5 absolute opaque
- 10/20 deep matte
- 30/40 opaque
- 50/60 semilucid
- 80/90 full glossy
• EN71.III Certification - Safe for children's toys
• IBR Certification - Insitute of greenbuilding Rosenheim
• French VOC Class A+ Certification
Code NAT4100-XX 6 x 1Lt
Code NAT4101-XX 2 x 2,5Lt
Code NAT4102-XX 2 x 5Lt
Code NAT4103-XX 1 x 10Lt
Code NAT4104-XX 1 x 20Lt
CATALYST NAT4100-2K
Cod. Desc. Pack.
NAT4099-2K 12 x 100 ml
NAT4100-2K 12 x 250 ml
NAT4101-2K 12 x 500 ml
NAT4105-2K 6 x 1 Lt
NAT4103-2K 2 x 2,5 Lt
NAT4104-2K 2 x 5 Lt
LOGIN
Apply on a smooth and clean surface, free from oils, greases, waxes, silicones and old varnishes, properly sanded.
If used as bicomponent mix varnish and Catalyst 4100-2K in ratio 10 : 1, stir very well then add 5- 10% of water (possibly demineralized), and stir again. Wait 10 minutes.
Apply in two or three coats (80-100 mL/m² each), depending on the final desired touch of the finish.
Wait 12 hours and sand with abrasive paper grit 220, aspirate with care all the dust and clean with an antistatic cloth. Then apply the next coat of Parketlack.
LEGENDA
Conformity EN 71.3 Toy safety - Part 3: Migration of certain items.
Eurofins danish laboratories have recognized the conformity of Borma Wachs oils to EN 71-III norm, relating to the migration of harmful heavy metals, guaranteeing the safety of the treatments in such a way that they can also be safe for use on childrens' toys.
Labeling of construction products
This label covers the French legislation relating to emissions of volatile organic compounds (VOC) and the impact they have on indoor air quality after the product is brought into the room.
Labeling refers to the pollutants emitted once the products are spread and dried.
The IBR Green Building Institute had tested some of our products and determined that they correspond to the highest standards of the aforementioned French VOC legislation.
EMICODE EC1 - Low-emission building materials
Certified installation materials, adhesives and construction products
The EMICODE mark guarantees that the material has been tested and certified according to its emission level. Compared to 1997, low-emission building materials now have a TVOC value (total quantity of volatile organic compounds) from one hundred to one thousand times lower. The EMICODE mark is not issued if a building material is suspected of altering genetic makeup, causing cancer or impairing reproductive capacity.
APEO (alkylphenol ethoxylates)
APEOs (alkylphenol ethoxylates) are highly persistent chemicals, which are deposited in the tissues, penetrating, through them, into the food chain.
Recent studies demonstrate its toxicity and danger, as potential endocrine disruptors.