headertop
PRODUCTS
Home / INTERIORS - Protection - Protection - Naturaqua Line Protection

NATURAQUA PARKETTLACK 1-2K

WATERBASED LACQUER FOR PARQUET
code NAT4100-XX
whatsapp

img_certICON_LINE_INTERNIICON_ADD_ACQUAICON_CERT_EN713ICON_CERT_IBRCERT_DGALN
Description

Waterbased varnish eco-friendly for the parquet floor treatment. High performances with the convenience of a single component / catalyzable technology. It can be used as a single component product, or can be activated with Catalyst 4100-2K, with the ratio varnish : catalyst = 10 : 1. Respects environment and the workers’ health, being waterbased and practically VOC free. With Parketlack very high protection levels can be obtained against wear and abrasion, for traditional wooden floors, pre-sanded or to be restored.

Sheen (Gloss):
- 0/5 absolute opaque
- 10/20 deep matte
- 30/40 opaque
- 50/60 semilucid
- 80/90 full glossy

Packaging

Code NAT4100-XX       6 x 1Lt
Code NAT4101-XX       2 x 2,5Lt
Code NAT4102-XX       2 x 5Lt
Code NAT4103-XX       1 x 10Lt
Code NAT4104-XX       1 x 20Lt

CATALYST NAT4100-2K
Cod.       Desc. Pack.
NAT4099-2K       12 x 100 ml
NAT4100-2K       12 x 250 ml
NAT4101-2K       12 x 500 ml
NAT4105-2K       6 x 1 Lt
NAT4103-2K       2 x 2,5 Lt
NAT4104-2K       2 x 5 Lt

Method of Usage

1

Apply on a smooth and clean surface, free from oils, greases, waxes, silicones and old varnishes, properly sanded.


1

If used as bicomponent mix varnish and Catalyst 4100-2K in ratio 10 : 1, stir very well then add 5- 10% of water (possibly demineralized), and stir again. Wait 10 minutes.


1

Apply in two or three coats (80-100 mL/m² each), depending on the final desired touch of the finish.


1

Wait 12 hours and sand with abrasive paper grit 220, aspirate with care all the dust and clean with an antistatic cloth. Then apply the next coat of Parketlack.

catalogoprodimg