Water-based high resistance eco-friendly lacquer ideal for the treatment and active cleaning of wooden floors.
It develops high levels of performance against wear and abrasion, as the innovative iG PURE technology grants additional sanitary protection.
Suitable for all types of wood, being self-sealer it does not necessarily require a specific primer.
Latest generation solution, self-regenerating protection with controlled Silver ions release.
Ready for use, (one component), can be easily spread on any treated surface.
On demand it can be further improved in performance by adding its specific hardener, (two component).
Hardener addition ratio is 10%.
Available in gloss levels: natural effect 5% - deep matt 10% - matt 30% - semiglossy 60% - glossy 90%.
Recommendations for application:
The product can be applied by brush or roller directly on sanded raw wood or on water-based, oil-based basecoats or oil-based finishes from Borma range.
Approx. yield: 10-14 m2/Lt
Sanitizing waterbased Parquet lacquer
- 0/5 absolute opaque
- 10/20 deep matte
- 30/40 opaque
- 50/60 semilucid
- 80/90 full glossy
Cod. IGNAT4100.1-XX - 6 x 1LT
Cod. IGNAT4100.5-XX - 2 x 5LT
Cod. IGNAT4100.10-XX - 10LT
Cod. IGNAT4100.20-XX - 20LT
Apply on a smooth and clean surface, free from oils, greases, waxes, silicones and old varnishes, properly sanded.
If used as bicomponent mix varnish and Catalyst 4100-2K in ratio 10 : 1, stir very well then add 5- 10% of water (possibly demineralized), and stir again. Wait 10 minutes.
Apply in two or three coats (80-100 mL/m² each), depending on the final desired touch of the finish.
Wait and sand with abrasive paper grit 220, aspirate with care all the dust and clean with an antistatic cloth. Then apply the next coat of Parketlack.
Drying time between the 2 coats: 2/4 hours